[Sparkling] The whole process of capturing the Apa snake using tape mummification

[Video Duration]: 00:46:27
[File Size]: 846MB
A big snake was drooling in front of me and serving me. I felt a little bit in danger of being eaten. This issue fully records how to make a girl into a snake mascot. It is low-cost and simple to operate, but it is quite time-consuming. The whole process takes 3 hours in total, and it is a one-time use.
After reading a mascot novel about a memorial ceremony, I couldn't forget the theme of a girl in a big snake costume using a breathing tube to maintain life. However, I couldn't buy such a costume in reality, so I decided to make a simple version.
Mummy wrap is the most suitable method. I bought 10 rolls of tape for this purpose, and ended up spending 6 rolls in total.
I will also open source the head shell of the Apa snake. Friends who can’t imagine turning into a snake can ask me to get the model file and print it by themselves.
This time I hope that the big snake can crawl. In order to prevent the tape from falling apart, I have to wrap it up many times. In Guangdong in December, the temperature is still over 20 degrees. Under the multiple layers of plastic wrap and tape, the inside of the big snake is still very stuffy.
Naturally, Orochi's target was Shigure. She had a mask on her nose and a breathing mouthpiece on her mouth. After turning into Orochi, Orochi's tongue became her breathing tube. However, it was too long and would often bend and bend, making her unable to breathe.
The big snake's saliva, which could not be swallowed, was all over the living room. The saliva flowed down the snake's mouth and passed through the teeth, as if a hungry beast was preparing to hunt.
However, it is completely impossible to let a big snake crawl. In fact, it is difficult for a big snake to even turn around.
In the end, the big snake evolved a hand and served to regain her master.